Bair Hugger Security Systems Service Manual Page 18

  • Download
  • Add to my manuals
  • Print
  • Page
    / 35
  • Table of contents
  • TROUBLESHOOTING
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 17
Bair Hugger Model 775 Temperature Management Unit Service Manual
14
Check the 3M
TM
Bair Hugger
TM
therapy website to ensure you have the most recent version of this document. www.bairhugger.com reorder #202526A
Testing the Over-Temperature Detection System
warning
Do not perform the over-temperature detection system test while the temperature management unit is being
used for temperature management therapy� ermal injury may result�
caution
Connect each warming unit being tested to a separate power source�
Service frequency
Every 6 months or 500 hours of use, or whenever service is performed
Tools/equipment
Model 22110 Temperature Test Unit
Method
note
If continuing from the previous section (Calibrating the Operating Temperature) skip to step 4�
note
If the temperature management unit has been stored at a temperature lower than 20°C, allow it to reach
ambient temperature before beginning the test
1� Connect the temperature management unit to a grounded power source� e unit performs a self-test
and automatically proceeds to Standby mode�
2� Connect the temperature test kit to the hose of the temperature management unit�
3� Press the Ambient button and allow the temperature management unit to run for 5 minutes�
note
Verify unit is set to the high fan ( ) setting by ensuring the indicator light by the upper fan
is illuminated
4� Press the Alternative Mode button (See "Figure 2� Location of Alternative Mode button" on
page11) and the 43°C button simultaneously for 3 seconds� e temperature management unit is
now in the Over-Temperature Detection Test mode� In this mode, the temperature management unit
performs the following tasks:
• Blower remains ON
• Heater elements turn ON at full power�
• 43°C indicator light ashes
• Over-temperature timer activates
• “OT Test” ashes in the alphanumeric display
Page view 17
1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 34 35

Comments to this Manuals

No comments